Thermal imaging is the common term but building inspection service providers like use the term ‘infrared thermography’. Here the building inspector will conduct his or her inspection of a property using thermal imaging equipment.

It is a modern, efficient and non-destructive way to make sure a property is capable of keeping moisture at bay. On top of that, a building’s energy efficiency, structural defects, overall condition of its electrical as well as plumbing systems can also be determined easily using this method.

A few advantages of thermal imaging in building inspections

Construction defects can be easily pointed out using the non-invasive thermal imaging inspection process.

If pest infestation is an issue in a building, without tearing down walls, the inspector can figure out the pest ‘hotspots’ and that too in real time.

It is one of the most efficient and safest ways an inspector can conduct an inspection of a building where it is nearly impossible to reach using traditional methods.

Other compelling reasons to use thermal imaging in building inspections

Long story short – it is a non-destructive and efficient way to carry out building inspections

Infrared equipment enables modern-day building inspectors to efficiently measure the surface temperature of a property using infrared light waves. This allows the inspector to see inside the property without poking holes in its walls or destroying a section of the building only to take a look at its structural integrity.

Infrared imaging also allows the inspector to make sure that proper weather-proofing of the property is achieved or not. One can also make sure that the building is properly insulated – a trait that is essential to deem property energy efficient and appropriate to reside or work in.

When it comes to building inspections, property owners and building inspectors both know the importance of both exterior and interior inspections. Internal building inspection using thermal imaging equipment will allow the inspector to conclude whether the property is insulated properly.

On top of that, whether the electrical wiring inside the property is producing arcs due to faulty wires. It can also be used to decide whether the plumbing system of the property is functioning as it should.

How a property owner can prepare for a thermal imaging backed building inspection?

To get the right results, property owners should make sure that there is a huge temperature difference between the exterior and interior temperatures of the property. Depending on the season, this particular situation can be achieved by either turning on the AC or the heating system of the property.

Normally a building inspector would take more than three hours to conduct an in-depth inspection of a property. Since building inspections are an important aspect these days, it is natural for it to take so much time to complete. With the advent of thermal imaging, the work of a building inspector becomes much easier. Instead of examining each section of the roof individually, the inspector can use thermal imaging equipment and carry out an inspection of the entire roof at a single go.

Leave a Reply